 |
This kit is based on Armstrong's
original design, with an tube RF amplifier stage which improves
reception of weak signals, a tube regenerative detector stage,
and a solid state audio amplifier stage with high quality 4 inch
loud-speaker which provides ample listening volume. This type of
receiver was popular in the mid to late 1930's.
Easy assembly - all the components are mounted on a high quality
silk-screened fibre glass printed circuit board.
No coils to wind - that has already been done for you! And
simple to follow instructions with both schematics and wiring
diagrams!
The kit comes complete with a silk screened front panel, a
rear panel and high quality speaker.
The iGen receivers run off 12 volts, so are completely safe
to build and use, no nasty high voltages, it is a great way to
learn a new hobby!
You get a manual, all the parts including valves,
sockets, jack plugs, tuning capacitors, coils, resistors, wire,
nuts and bolts etc.
Specifications
- Type: Regenerative Hybrid Tube and Solid State
- Tube #1: RF Amplifier stage
- Tube #2: RF Detector stage
- Tuning: Air Variable Capacitor with built in 3:1
reduction
- IC Amp: 1/3 watt Audio amplifier stage
- PCB: high quality silk screened printed circuit board
- Front Panel: high quality silk screened panel
- Output: High quality 4 inch speaker
- Power 12V DC Batteries or optional 12V Mains Adapter
- Coverage: Broadcast Band / Medium Wave
- Controls: Regeneration, Volume, Tuning
- Connections: Aerial, Earth, Phone
Optional Accessories
- UK 12V Mains Adapter see Part No IGEN-UK-PSU
- Set of Short Wave coils see Part No IGEN-SW-COIL
- Low Impedance Headphones see Part No IGEN-PHONES
|
